BH FITNESS LK500Ui Mode D'emploi page 17

STEP 3
SEAT PAD AND PEDAL ASSEMBLY
Take off the screw nut and washer on Seat Pad (N) and set aside. Attach the Seat Pad (N)
onto the Seat Set (O) with the screws, nuts, and washer, that were set aside, and tighten
securely. Slide the Seat Set (O) into the Seat Tube (F), install and tighten the CKS Screw (K-
11). Adjust the seat forward or back and secure with the knob under the back of the Seat Set.
Then, pull the POP PIN out and put the Seat Tube (F) into the Main Frame (A) (follow the
arrow as seen in figure below). Once the seat is at the desired height, tighten the handle on
the POP PIN to secure the Seat Tube (F). Finally assemble the hen assemble Left and Right
Pedals (J,I).
Note: Pedals are labeled left and right, please place them on the appropriate side.
F
A
17