Maintenance And Inspection; Safety Measures; Maintenance And Inspection Table; Note On Care - CEMO SW 200 Manuel D'utilisation

GB

9. Maintenance and inspection

9.1 Safety measures

i
Important!
The operator must provide any protective
clothing that may be required.
Normal maintenance work may be carried out by
operational personnel.

9.2 Maintenance and inspection table

Interval Assembly
Spreader
After each
use
Moving
parts
Fastening
elements
after 8
operating
hours
Wheels
Paint
damage
As
required
Spreader
i
Important!
The gearbox is lubricated for life and there-
fore maintenance-free.
22
Action
Clean off any stuck-
on dirt or residues of
spreading material.
Lubricate with mineral
universal grease.
Check for secure seat
and tighten if neces-
sary.
Check air pressure 0.8-
1.2 bar and correct if
necessary.
Lubricate with grease
gun (mineral universal
grease) via lubricating
nipple.
- 2 lubricating nipples
per wheel.
- 1 lubricating nipple on
the bearing of the
vertical axle
Remedy paint
damage with
2K PU paint RAL 2008.
Check for
defective parts and
replace defective parts
if necessary with
original spare parts
(see section 11).

9.3 Note on care

All parts that come into contact with the media are
stainless steel or plastic.
• The device must be thoroughly cleaned after each
use, especially after the use of salt.
• When using a high-pressure cleaner to clean the
device, the lighting must be protected.
• Dry the device after cleaning.
• After cleaning, you should treat the moving
parts in particular with a light, rust-dissolving or
water-displacing oil (e.g. WD-40).
• The tyre pressure must be checked at regular
intervals.
The setpoint is 0.8 – 1.2 bar.

10. Decommissioning

1. Empty the spreader hopper.
2. Disassemble the spreader into its
constituent parts.
3. Sort accordingly by material.
4. Dispose of in compliance with local regulations.

11. Spare parts list

at the end of the operating instructions

12. Warranty

Under our general terms and conditions of trade we
warrant that the spreader will be produced free from
defects in materials, functionality or workmanship.
These can be inspected at
http://www.cemo.de/agb.html
The warranty applies only under the condition that
the above operating and maintenance instructions
and all applicable regulations are closely followed.
Modification of the spreader by the customer
without consultation with the manufacturer CEMO
GmbH invalidates any claims under the statutory
warranty.
CEMO GmbH also accepts no responsibility for
damage caused by inappropriate use.