Change The Spark Plug - Sears C950-52943-0 Manuel D'utilisation

Chasse-neige à deux phases 13.5 t.p. 27 pouces
Table des Matières

Publicité

CHANGE THE SPARK PLUG

Remove the Snow Hood
1. Remove the choke control knob (A A , Figure 28).
2. Remove the safety key (B B ).
3. Remove the mounting screws (A A , Figure 29).
4. Slowly remove the snow hood (B B ) Make sure that the primer button
hose (C C ) and the ignition wire (D D ) are not disconnected.
5. The spark plug (E E ) can now be accessed.
6. To install the snow hood, first make sure that the primer button hose
and the ignition wire are connected.
7. Mount the snow hood to the engine and secure with the mounting
screws.
8. Connect the choke control knob (A A , Figure 30) with the choke shaft
on the carburetor (B B ). Make sure the choke control knob is properly
installed. If the choke control knob is not installed correctly, the choke
will not operate.
9. Install the safety key (C C ).
A
B
Snow Thrower Engine
D
E
Removing the Snow Hood
Connecting Choke Control Knob
Figure 28
25
MAINTENANCE
B
A
A
C
Figure 29
B
C
Figure 30

Publicité

Chapitres

Table des Matières
loading

Table des Matières