Ibx H20D Mode D'emploi page 4

Check the instrument and the accessories for damage prior to every use. Do not use damaged

components. A safe operation is only guaranteed with the accessories described in the
"Accessories" chapter. Accessories must be securely attached to the device and cannot come off
by themselves. Always disconnect the plug before the assembly or disassembly of accessories.
When the external temperature sensor is needed, the tip of the measuring sensor must be at

least 5-10 mm away from the vessel bottom and wall.
The equipment can only be disconnected from the main power supply by pulling out the mains

plug.
The voltage stated on the label must correspond to the main power supply.

Make sure that the cable does not touch the hotplate. Do not cover the device.

The instrument may only be opened by experts.

Keep away from high magnetic fields.

Observe the minimum distances between devices, between the device and the wall, and above

the device (min. 100 mm.)
>100mm
Figure 1
4