Troubleshooting Guide - Oreck XL BB1000 Série Mode D'emploi

E N G
Maintenance and Customer Service
Your ORECK COMPACT CANISTER VACUUM is a product of
precise engineering. The motor bearings are permanently
lubricated and should not be oiled. If you require additional
information or have problems with your ORECK appliance, you
may call ORECK customer service at:
US: 1-800-989-3535
Canada: 1-888-676-7325
Please specify the model number and serial/code number which
can be found on the data plate on the bottom of the vacuum.
Save your sales or purchase slip. Should your ORECK
appliance require warranty service in the U.S.A., present this slip
to the Authorized Service Center as your proof of purchase date,
or, in Canada, call customer service.

Troubleshooting Guide

P P
ROBLEM OSSIBLE
Cleaner Will 1.Not plugged in
Not Run properly
2.No electricity in
wall outlet.
3.Motor protector
tripped.
4.Needs service.
Vacuum Will 1.Filter bag is full.
Not Pick Up
Or Has Low
Suction
2.Hose/wand tool
is clogged.
3.Air leak due to
missing or
damaged gasket.
1.Proper friction fit
Tools/Wands
not being
Will Not Stay
Together obtained.
ALL OTHER SERVICING SHOULD BE DONE BY AN
ORECK AUTHORIZED SERVICE CENTER.
CALL CUSTOMER SERVICE HOT LINE
US: 1-800-989-3535 Canada: 1-888-676-7325
Whenever calling, please be sure to have your model and serial
number from data plate.
L I S H
S A C
OURCE REAS TO HECK
1. Be sure cleaner is
firmly plugged into
wall outlet.
2. Check electrical
source–fuse or
circuit breaker.
3. See Motor
Protection System
page 2.
4. Take to service
center or call for
nearest service
center.
1. Replace filter bag.
See "To Replace
Filter Bag," page 4.
2. Remove
obstructions.
3. Replace gasket
See page 4.
1. Push and turn.
T O U T S I M P L E M E N T É T O N N A N T
G D'
UIDE
F R A
NOIR AVEC DES ROUES
•IMPORTANTE•
CONSERVEZ CE FASCICULE
Comprend:
Avertissements de sécurité
Nomenclature
Mode d'emploi
Guide de dépannage
Accessoires
5
UTILISATION
N Ç A I S
Garantie
Entretien
®