Terk OMNITV3A Mode D'emploi page 8

Installation
To connect the OMNITV3A without the amplifier
directly to your TV:
OMNITV3A
Note about digital channels
To display digital signals on your TV, you'll need
to have the right equipment: either a TV that is
capable of decoding digital signals or a digital
converter box.
7
(continued)
1. Make sure your TV is turned
off.
2. Connect the OMNITV3A's built-
in coaxial cable to the antenna
input on your TV.
Built-In
Coaxial Cable
3. Run your TV's tuner/channel
setup to scan for available
broadcast channels.
TV