Terk OMNITV3A Mode D'emploi page 7

Installation
To connect the OMNITV3A with the amplifier directly
to your TV:
OMNITV3A
6
Built-In
Coaxial Cable
ANTENNA
Amplifier
Insert
TV/STB
TV
(continued)
1. Make sure your TV is turned
off.
2. Connect the OMNITV3A's
built-in cable to the input jack
of the amplifier.
3. Connect the amplifier's built-
in cable to the antenna input
on your TV.
4. Plug the amplifier's power
cord into an electrical outlet.
Important: This power unit
should be plugged in so that it
stays vertical or lays flat.
5. Run your TV's tuner/channel
setup to scan for available
broadcast channels.