Beko DC 7430 Manuel De L'utilisateur page 40

6
Suggested solutions for problems
Drying process takes too much time
• Meshes of the lint filter may be clogged. Wash the lint filter with warm water.
Laundry comes out wet at the end of drying.
• Meshes of the lint filter may be clogged. Wash the lint filter with warm water.
• Excessive laundry might have been loaded in. Do not load the dryer in excess.
Dryer does not switch on or the programme does not start. Dryer does not start when it is set.
• It might have not been plugged in. Make sure that the machine is plugged in.
• The loading door may be ajar. Make sure that the loading door is properly closed.
• Programme might have not been set or the "Start/Pause/Cancel" button might have not
been pressed. Make sure that the programme has been set and it is not in "Pause" mode.
• "Childproof lock" might have been activated. Deactivate the Childproof Lock.
Programme is interrupted without any cause.
• The loading door may be ajar. Make sure that the loading door is properly closed.
• Electricity may be cut off. Press "Start/Pause/Cancel" button to start the programme.
Laundry has shrunk, become felted or deteriorated.
• A programme suitable for the laundry type might have not been used. Dry only the laundry
which is suitable for drying in dryer after checking the labels on your clothes.
• Select a programme with suitable low temperature for the laundry type to dry your clothes.
Drum lightning does not come on. (For models with lamp)
• Make sure that the dryer is switched on.
• Bulb may have blown. Call the authorised service agent to replace the bulb.
"Filter cleaning" symbol is on.
• Lint filter might have not been cleaned. Clean the filter cassette.
"Water leaks from the door"
• Clean the entire inner surface of the door and door gasket.
"Door opens spontaneously."
• Push it until you hear that it is closed.
For products with a condenser:
"Water tank" warning symbol is on.
• Water tank may be full. Drain the water in the tank.
A
Call an authorised service agent if the problem persists.
40 EN