Dali E Série Mode D'emploi page 8

4.3 Adjustment of Switches
When the grille is removed from the loudspeaker, you will see the woofer and the tweeter and two
switches (see figure 6). The switches can be used to adjust the sound from the loudspeaker to a
custom setup. The switches can be operated independent of each other.
One switch can increase the tweeter level 3 dB if it is switched from the "Normal" setting to the
"HF tilt" setting.
The other switch can focus or distribute the sound from the loudspeaker. When the listeners
are relatively close to the center axis of the loudspeaker (closer than 25 degrees off-axis) we
recommend setting the switch to the "Focus" setting. When listening far away from the center
axis of the loudspeaker (more than 25 degrees off-axis) or if the speaker is used to fill a large area
with sound, we recommend setting the switch to "Distributed".
The PHANTOM E-60 S comprises a woofer, two tweeters and two switches (see figure 6B). The
switches can be used to adjust the sound to suit the listening room and personal preferences. The
switches can be operated independently of each other.
One switch will increase the left channel tweeter level by 3 dB between the "Normal" and "HF+"
settings. The second switch similarly adjusts the right channel tweeter.
When listeners are relatively close to the center axis of the loudspeaker (closer than 25 degrees
off-axis) we recommend setting the switches to the "Normal" setting. When listeners are further
away from the center axis of the loudspeaker (more than 25 degrees off-axis), or if the loudspeaker
is required to fill a large listening area, we recommend setting the switches to "HF+".
4.4 Speaker Rotation – Using the Compass
When the grille is removed you can see a compass ring round the edge of the loudspeaker bezel,
which can be used to read out the rotation of the loudspeaker relatively to, for example, a fixed
line on the ceiling. The tweeter is slightly off-center and should be positioned so it is closest to the
main listening position (see figure 7).
The PHANTOM E-60 S incorporates a compass ring around the edge of its bezel (see figure 7B),
that can be used to read out the rotation of the loudspeaker relative to, for example, a fixed line on
the ceiling. The tweeters should be positioned so they are closest to the main listening position.
4.5 Connection of Cables/Selection of Cables
Your choice of cables is a crucial element in your installation. Be aware that replacing cables after
installation is a difficult task. Therefore, select quality cables from the beginning. Please consult
your authorized DALI dealer for further advice on which cable to select.
When connecting the cable to the loudspeaker and the amplifier, it is important that the loudspeaker
is connected in correct phase. The red (+) loudspeaker terminal must be connected to the red (+)
amplifier terminal. The black (-) loudspeaker terminal must be connected to the black (-) amplifier
terminal. If the loudspeakers are not connected in correct phase, the soundstage will typically be
diffuse and the bass will be weak.
9