Makita SKR60 Mode D'emploi page 6

Using the Built-in Wall Mount
Height
adjustment
clamp (9)
Setup on Ceiling Grid
1) To hang the SKR60 from a ceiling grid, open the
height adjustment clamp (9) on the side of the wall
mount. Raise to the height desired and lock.
2) Open the top grid clamp (12), place the wall
mount against the grid, and lock. The grid cannot be
thicker than 1/8''(3mm).
3) Use the height adjustment clamp for final
positioning. Level the laser. Check that both vials
are still centered whenever laser position is changed.
Grid
clamp (12)
Adjustable
slope lock (15)
6
Tripod mount
(16)