Installation - INVENTOR QLT-300 Manuel D'utilisateur

|Installation

1
Remove rear housing
Grasp the position of the button
to pull out and lift it up, and
then remove the rear housing
2
Install the filter
Hold the filter elements on both sides of
the belt, remove the filter elements
Open the packing bag of the filter
Install the filter elements in the direction of
the arrow shown at the top of the filter
Please make sure that the filter elements
are properly installed on the front and rear
sides.
EN
3
Install the rear housing
Insert the bottom buckle of the rear
housing into the slot at the bottom of the
body
Press sides simultaneously by hands and 4
buckles on the left and right are inserted in
the body
Press the top simultaneously by hands
7