Safety Feature - INVENTOR G3INV-20DTB Manuel D'emploi

NOTE: Temperature Control and Setting Timer can be activated both from the central unit or
from the remote controller.
1.6 CHILDREN SAFETY LOCK FUNCTION
Under the working mode, press both " " and " " at the same time for 3 seconds to lock the
system. Then a square " " is displayed. 3 seconds later it resumes to inspection temperature
display status. If there is a key pressed, the symbol " " will show for 3 seconds without buzzer
hint, and then it resumes to inspection temperature display status again. Methods to unlock:
1) Turn off the unit by the side button. 2) The timing previously set is completed 3) Press both
" " and " "for 3 seconds.
NOTE: Only from the main unit (not the remote controller)
1.7 POWER SELECTION
Press button " " to select the output power. The heater will work with the full Rated output
when "HI" is displayed. Press button " " again to switch to "LO" heating mode.
1.8 ACTIVATION OF THE ION GENERATOR
Press the " "on, the ION indicator will be on, then the ion will start operating, which can make
the room-air cleaner. Press once again " " to deactivate.
1.9 LOCKING THE CONTROL PANEL FUNCTIONS
1.9.1 ELECTRONIC LOCKING - Refer to section 1.6

2. Safety feature

The unit is equipped with a high limit switch; the heater will automatically shut down if it is in an
over-heating condition.
It will automatically restart when it cools down.
3. Cleaning behind the heater
It is very easy to clean behind it. For mount ceiling installation: Hold two sides of the heater, pull
the unit upwards and then forward, then you can clean behind.
After cleaning, the heater must be placed in the normal position.
The heater requires regular cleaning to ensure trouble-free operation:
Unplug the heater from the mains supply before cleaning.
Ensure that the heater has cooled down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of the heater, so as to remove dust and dirt. Use
a vacuum, cleaner to remove dust and fluff around the grilles.
Ensure the heater is dry before plugging back into the mains supply.
6