Placement; Installing The Door Handle - INVENTOR RT49-50B Manuel D'utilisateur

9. PLACEMENT

Installing the Door Handle

Step 1: Initially install the handle base into the reserved holes on the door, and tighten the
screws firmly.
Step 2: Align the handle cover with the hole on the handle base.
• Prior to use, remove all
the packaging materials
including the bottom
cushions and remove
the protective film on
the door and body of the
Refrigerator.
• Avoid direct sunlight
and heat sources such as
stove, heating radiator,
etc. If the unit has to be
put next to heat source,
a suitable insulationboard
shall be appliedor keep
the cooler away from heat
source.
Step 1
10
• The placement of the
Refrigerator should be in
a well ventilated indoor
area. The ground should
be sturdy and leveled.
You may fine adjust the
stability by adjusting the
leveling foot.
• The clearance
distances are as follows:
30cm from the top of the
Refrigerator and10cm's
from the sides and the
back.
Step 2