Treatment Steps - Silk-n BRIGHT ND-FC04 Mode D'emploi

7 Treatment steps

EN
1. Make sure the facial brush has enough battery power before
use (see chapter "Charging").
2. Dampen your face and the facial brush with lukewarm water.
Apply your regular face wash product on the face (see step 1
in Fig. B).
3. Turn on the facial brush, select the vibrating mode and a speed
setting (see chapter "Operation").
4. Cleanse the face by moving the cleansing area (
the face in circular movements. Use the area with thicker studs
for areas that need precise cleansing (e.g. around the nose, eyes
and chin) and use the area with thinner studs for the larger
areas (e.g. forehead, cheeks and neck) (see step 2 in Fig. B). The
facial brush will automatically switch off after 2 minutes.
5. Thoroughly rinse the face and facial brush with water and then
wipe them dry with a clean, dry towel (see step 3 in Fig. B).
6. Apply your serum or day/night cream on the face.
7. Turn on the facial brush and select the pulsating mode and a
speed setting (see chapter "Operation").
8. Massage the face by moving the massaging area
face in circular movements to stimulate blood circulation and
promote the absorption of your skin care product (see step 4
in Fig. B). The facial brush will automatically switch off after
2 minutes. If you want to end the treatment earlier, press the
control button ( )
more than once, depending on the product version and
current operation mode.
9. Thoroughly clean the facial brush after use (see chapter
"Cleaning").
• You can divide the skin into 6 areas: forehead,
• This facial brush is designed to cleanse your skin in just
• Do not use this facial brush more than twice a day as
15
. You may have to press the button
6
nose, chin, left cheek, right cheek and neck. We
recommend you not to treat each area for more than
20 seconds.
2 minutes. We recommend you not to exceed this
time.
this can irritate the skin and cause redness.
or ) over
1 2
over the
4