entrematic BASE MATIC Instructions D'installation page 6

GENERAL AND INTRODUCTION
Installation of a garage door requires
technical knowledge and skills. The manu-
facturer is not responsible for damage to
equipment or personal injury that occurs
during assembly. Contact a skilled crafts-
man at the slightest doubt of one's ability
to install the door securely and accurately.
For reasons of safety study the instructions
carefully and make sure that you under-
stand them before beginning the instal-
lation. These installation instructions are
supplied with pictures. The manufacturer is
not liable for damage or functional defects
caused by not following the installation
instructions. For reasons of safety it is pro-
hibited to modify the door without approval.
If the door or its mechanism are modified,
or if an extra weight is fitted on the door,
the warranty will be void.
SAFETY
The mounts supplied with the door are
for walls and ceilings of ordinary brick,
wood, steel and concrete. If the door must
be fitted on other materials or if the walls
and ceiling are of a poor quality, it is the
installer's responsibility to use appropriate
good quality fittings. These can easily be
purchased from retail outlets. Use plugs
and screws with washers intended for the
wall material in question.
Important information and comments are
displayed with the following symbols:
WARNING!
Operations that require extra caution so
that no one gets injured.
PACKAGING
The door's packaging consists of materials
that can be recycled. Dispose of packaging
in accordance with the country's provi-
sions.
WORKING AREA
The door opening and garage floor must
be completed before the garage door is
installed. Always lay out the door sections
on a suitable surface (such as clean card-
board) so that none of the door surfaces
are damaged. Make sure you have all the
tools required to assemble the door inside
the garage before starting the installation.
MAINTENANCE
Every six months
Check the condition of the door wires and
replace if damaged. Check the condition
of the wall and ceiling mounts. Tighten if
necessary. In order to maintain the door
appearance. Wash the door sections with
a clean sponge and a normal car sham-
poo. Rinse well with clean cold water. Do
not use abrasive cleaning agents, cleaning
agents may scratch the door.
Every twelve months
Lubricate the hinges with standard oil.
SPARE PARTS
For reasons of safety, only use original
parts from the manufacturer. The use of
other parts can involve a safety hazard
and void the warranty. First and foremost,
contact the person who installed the door
if you need to buy spare parts or have it
serviced. When ordering spare parts state
the garage door number, which is located
on the identification decal on the upper
part of the right wall rail.
DISMANTLING
Removal of the door must be performed
by skilled personal. Dismantle the door in
the reverse order compared to the installa-
tion instruction.
6
GB