Care And Maintenance - Utilitech Pro 00P9016 Mode D'emploi

TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE
1. The sensor may be detecting daylight or
The light will
not
2. The SENSITIVITY may be set too low.
illuminate.
3. The battery is low or drained.
4. The solar panel plug isn't properly
5. The battery plug isn't properly connected.
1. If there is frequent activity from dusk to
The battery
does not
fully charge.
2. There is no enough sunlight.
3. There is dust and debris on the solar
4. The cable of solar panel may be
1. The SENSITIVITY may be set too high.
The light
2. There are other movements that trigger
stays on
the light.
continuously.
1. The motion is directly towards the sensor.
Motion is not
2. The light may install at the place near air
detected
within the
3. There is dust on motion sensor lens.
coverage
area.

CARE AND MAINTENANCE

This LED motion-activated light provides
Do not touch LED or open fixture housing.
To clean, turn OFF all power to circuit and clean surfaces with a mild, non-abrasive cleaner.
It will be necessary to periodically clean the solar panel with soft wet cloth.
other bright light source near the unit.
connected.
dawn or continuous overcast days, the
solar panel may not convert sufficient
ambient daylight to recharge the battery
sufficiently.
panel.
damaged.
conditioner, central heater, or hot air flow.
years maintenance-free service with no bulbs to change.
9
CORRECTIVE ACTION
1. Reposition the installation
place to avoid other lighting
source.
2. Rotate the SENSITIVITY
knob clockwise in order to
make the detector more
sensitive to motion.
3. To charge the battery fully.
4. Make sure the solar panel
plug is fully inserted.
5. Make certain the battery
plug is connected inside
the battery compartment.
1. Avoid unnecessary activity.
2. Reposition solar panel to
receive more sunlight.
3. Clean dust and debris from
solar panel.
4. Make sure the solar panel
cable is not damaged.
1. Rotate the SENSITIVITY
knob counterclockwise in
order to make the detector
less sensitive to motion.
2. Avoid other movements may
trigger the light needlessly.
1. The sensor is more sensitive
to motion which is across the
detection field than directly
towards the sensor.
2. Avoid installing the light near
such place.
3. Clean the dust on the lens.