For Your Safety - Würth master H 26-ACM Mode D'emploi

H 26 ACM.book Seite 8 Freitag, 25. November 2005 8:37 08
GB
Working safely with this machine
is possible only when the operat-
ing and safety information are
read completely and the instruc-
tions contained therein are strictly
followed. In addition, the general
safety notes in the enclosed book-
let must be observed.
If the mains cable is damaged or cut
through while working, do not
touch the cable but immediately pull
the mains plug. Never use the
machine with a damaged cable.
Wear hearing protection.
Wear safety glasses and sturdy
shoes.
For long hair, wear hair protection. Work only
with closely fitting clothes.
Use appropriate detectors to determine if util-
ity lines are hidden in the work area or call the
local utility company for assistance.
Contact with electric lines can lead to fire and
electric shock. Damaging a gas line can lead to
explosion. Penetrating a water line causes
property damage or may cause an electric
shock.
Hold the power tool only by the insulated
gripping surfaces, when performing an oper-
ation where the cutting tool may run into hid-
den wiring or its own cord.
Contact with a "live" wire will make exposed
metal parts of the tool "live" and shock the
operator.
8

For Your Safety

Connect machines that are used in the open via
a residual current device (RCD) with an actuat-
ing current of 30 mA maximum. Use only
extension cables that are approved for outdoor
use.
During work breaks, when not in use or when
working on the machine (e. g. changing tool
inserts, repairs, cleaning, adjustments), pull the
mains plug.
Operate the machine only with the auxiliary
handle 10.
Always direct the cable to the rear away from
the machine.
Do not carry or hang up the machine by the
cable.
Insert the mains plug only when the machine is
switched off.
When working with the machine, always hold
it firmly with both hands and provide for a
secure stance.
Always switch the machine off and wait until it
has come to a standstill before placing it down.
Never allow children to use the machine.
Do not drill into housing or attach rivets in order
to mark the machine. The double insulation is
then no longer ensured. Use stickers.
Use only original Würth parts and accesso-
ries.
For further notes on safety refer to the enclosed sheet