Maintenance And Cleaning - Würth master H 26-ACM Mode D'emploi

H 26 ACM.book Seite 10 Freitag, 25. November 2005 8:37 08
Inserting and removing tools
Only use the appropriate tools for the
SDS-plus® tool mounting.
Clean and lightly lubricate tools prior to use.
Insert the tool into the tool mounting while rotating it
until it engages.
Check that it has engaged by pulling on the tool.
Push the auto-locking sleeve 2 back to remove the
tool.
Replacing the Tool Holder (see figure C)
For removal of the tool holder, turn the locking
ring 3 to the unlock position
holder.
Clean any dust deposits from the spindle and the
tool holder and lightly lubricate with grease.
Insert the tool holder onto the spindle to the stop and
turn the locking ring to the lock position
The tool holder is locked when it can no longer be
pulled off of the spindle.
Drilling without impact drilling and
chipping
Fitting the tool.
Set the mode selector switch 6 to
Press the On/Off switch 9 to adjust the speed or
switch the machine on and off.
Chipping
Fitting the tool.
Set the mode selector switch 6 to
Turn the tool to the desired angle.
Set the mode selector switch to
Press the On/Off switch 9 to switch the machine on
or off or to set the speed.
10
Before any work on the machine itself, pull the
mains plug.
Keep the tool holder clean at all times.
Changing the Dust Protection Cap
A damaged dust protection cap should be changed
immediately. We recommend having this carried
out by an after-sales service.
If the machine should fail despite the care taken in
and take off the tool
manufacturing and testing, repair should be carried
out by a Würth Master-Service agent.
In all correspondence and spare parts orders,
please always include the 8-digit order number
given on the nameplate of the machine.
.
For the current spare parts list of this machine, log into
the Internet under "http://www.wuerth.com/parts-
manager" or ask for a copy at your nearest Würth
branch office.
or .
Power tools, accessories and packaging should be
sorted for environmental-friendly recycling.
.
incorporation into national law, power tools that are
.
no longer suitable for use must be separately col-
lected and sent for recovery in an environmen-
tal-friendly manner.
Würth will gladly take back your defective Würth
power tool free of charge.

Maintenance and Cleaning

For safe and proper working, always keep the
machine and the ventilation slots clean.
Disposal
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EC on waste electrical
and electronic equipment and its