Napoleon Bayfield GDS25N-1 Manuel D'installation page 35

Masquer les pouces Voir aussi pour Bayfield GDS25N-1:

Table des Matières

Les langues disponibles

This time delay is designed to maximize the blower distribution of heated air.

Use the UP/DOWN arrow keys to adjust the output level.

single beep will confirm reception of the command.

If at any time the burner re-ignites before the twelve minutes are over, the fan will continue to run.

ADD TITLE: CONTINUOUS PILOT / INTERMITTENT PILOT (CPI / IPI) SELECTION

note:

At any time in the sequence, the blower (if equipped) can be manually turned on/off using the remote

A. When the transmitter is in the "OFF" position, use the Mode Key to guide

control.

you to the CPI mode icon.

7.8

key lock

B. Press the UP/DOWN to switch between IPI and CPI modes. A single BEEP

ADD TITLE: CHILD PROOF FUNCTION

will confirm reception of the command.

This function will lock the keys to avoid unsupervised operation.

note:

A. Press the MODE and UP keys at the same time.

If the appliance is equipped with a CPI/IPI toggle switch, set the CPI/IPI to CPI

B. To de-activate this function, press the MODE and UP keys at the same time.

position to enable remote CPI operation. If the switch is set to IPI then it will

only work in IPI regardless of what is set on the remote control handset.

ADD TITLE: NIGHT LIGHT

7.9

low battery / manual bypass

ADD TITLE: LOW BATTERY / MANUAL BYPASS

The auxiliary function controls the AUX power outlet on the Control Module

which controls the NIGHT LIGHT™.

The life span of the remote batteries depends on various factors: quality of the batteries, the

number of ignitions, etc.

A. Use the Mode Key to guide you to the AUX icon.

When the transmitter batteries are low, a Battery Icon will appear on the LCD display before all

B. Pressing the Up Arrow Key will activate the NIGHT LIGHT™.

battery power is lost. When the batteries are replaced this icon will disappear.

C. Pressing the Down Arrow Key will turn the NIGHT LIGHT™ off. A single

When the receiver batteries are low, no "beep" will be emitted from the receiver when it

"beep" will confirm the reception of the command.

receives an ON/OFF command. This in an alert for the receiver that there's low battery. When

ADD TITLE: Night Light Dimmer Control

the batteries are replaced the "beep" will be emitted from the receiver when the ON/OFF key is pressed.

If the batteries of the receiver or transmitter are low, the appliance can be turned on manually by sliding the three

The auxiliary function controls the Night Light

position slider switch on the receiver to the "ON" position. This will bypass the remote control feature and the appliance

A. Use the Mode Key to guide you to the Night Light icon.

main burner will come on if the gas valve is in the "ON" position.

B. The intensity of the output can be adjusted through 6 levels.

ADD TITLE: IN THE EVENT OF A POWER FAILURE

Use the UP/DOWN arrow keys to adjust the output level.

If the receiver is equipped with batteries they will enable flame height control or ON/OFF function to control the

single beep will confirm reception of the command.

appliance during a power failure. Blower and NIGHT LIGHT operation is not possible. Refer to "APPLIANCE

ADD TITLE: CONTINUOUS PILOT / INTERMITTENT PILOT (CPI / IPI) SELECTION

OPERATION" section when communications between receiver and transmitter have been lost. The receiver will emit

A. When the transmitter is in the "OFF" position, use the Mode Key to guide

a "beep" sound to confirm programming has been successful once power is restored. During a power failure, if the

you to the CPI mode icon.

appliance was on, the flame height will stay at the setting prior to the failure. If off when the failure occurs and then

turned on, the flame height will come on at "HI". The flame height can then be controlled by the remote.