Log Placement - Napoleon B46NTR Instructions D'installation Et D'utilisation

46
6.3

LOG PLACEMENT

EN
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
PHAZER
logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that
TM
is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing
effect.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
A. Place the rear log (W135-0693) firmly onto the
two studs located at the rear of the support
tray. Ensure the log sits flat and does not
cover the pilot opening. Place two pins in
holes located on the top of the rear log.
C. Place the left middle log (W135-0695) onto the
two studs located on the left side of the log
support.
E. Place the lower left crossover log (W135-0698)
in the notch of the left middle log.
W415-1613 / D / 09.20.17
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
PINS
WARNING
!
B. Place the right middle log (W135-0697) onto
the two studs located on the right side of the
log support.
D. Place the lower right crossover log (W135-
0700) in the notch of the right middle log.
F. Place the upper right crossover log (W135-
0694) onto the pin located on the right side of
the rear log, allow it to rest in the notch of the
right middle log.
76.1A