Philips NIVEA HS8015/18 Mode D'emploi page 16

EngliSH
18
2 Turn the guard clockwise and lift it from the
shaving unit.
Note: Only remove one shaving head at a time. This
ensures that you always put the shaving head back
into its original holder, which is necessary because two
of the shaving heads have special holes for the shaving
conditioner. This also ensures that you do not mix up
the cutters and guards of different shaving heads,
which affects the shaving performance.
3 If necessary, remove the cutter from the guard.
4 Clean the cutter and guard with the brush
supplied.
5 After cleaning, place the cutter back
into the shaving unit with the cutter legs
pointing upwards.
6 Place the guard back onto the shaving head
holder (over the cutter).
7 Turn the guard anticlockwise until it locks into
position.
8 Put the shaving unit back onto the shaver
('click').