Power Led; Composite Video Output Bnc Connector; Power Supply; Lens Selection - Honeywell E Série Guide D'installation

Power LED

In normal operation, the LED on the rear panel of the camera is illuminated
when power is connected to the camera.

Composite Video Output BNC Connector

To obtain a 1.0 Vp-p composite video signal, connect a video coaxial cable
terminated with a 75 Ohm BNC connector to the BNC socket marked VIDEO
OUT.

Power Supply

The voltage required to operate the camera is clearly marked on the rear
panel of the camera. Connections are indicated above the terminals on the
rear panel of the camera.

Lens Selection

Suitable lens types are C- and CS-mount in fixed iris, manual iris, video auto
iris, or direct drive auto iris versions. Cameras are factory set for CS-mount
lenses.
If using a C-mount lens, rotate the back focus adjustment mechanism fully
clockwise (when viewed from the front of the camera) before fitting the lens.
See "Back Focus Adjustment" on page 6.
Rev 1.01 5 Document 900.0350
05/05