Mounting Instructions - Rointe T Série Mode D'emploi

If you do not wish to change the programming of a particular hour, continue to the next hour
you wish to change. Once all of the hours are programmed, or left blank without programming,
press the button to exit, or leave the unit for 30 seconds without pressing anything.

3. MOUNTING INSTRUCTIONS

Inside the box you will find a mounting kit.
1. Choose the right part of the wall.
2. Place the mounting stencil on the wall, marking the places for the holes.
3. Remove the stencil and make the holes in the wall.
4. Insert the rawl plugs in the holes made.
5. Screw the plastic fastener to the wall with the 6.3 x 50 mm screw.
6. Screw the two brackets for supporting the heated towel rail and the plastic fastener to the
horizontal tube of the heated towel rail like in Figure 1 with the 3/8" x 40 mm screw.
7. Insert what you have assembled in Section 6 into the plastic piece and fix well with the
2.9 x 9.5 mm stud bolt.
8. Place the cover on the piece supporting the heated towel rail.
8
Cross section of the towel rail
6
6
7
5
Figure 1.
1 10 mm Rawl Plug
2 Plastic Fastener
3 Screw 2.9 x 9.5 mm
4 Screw 6.3 x 50 mm
5 Plastic Fastener
6 Profile of Heated Towel Rail
7 Screw 3/8" x 40 mm
8
3
1
2
4
Cover
19