Installation Procedure - Viega Visign for Style 10 8315.1 Mode D'emploi

GB
Instructions for use: Visign actuating plates
B
Components

Inspection chamber

Base plate Visign for Style 10

Cover for chamber
C
Installation
The actuating plates can be located on the front or top of the cistern modules. The installation procedure
is identical for both locations.
We recommend that you wait until the wall finish is complete before installing the actuating plates.

Installation procedure

A
Remove the chamber cover.
D
Remove the cover and open
the corner valve.
G
Fit the base plate and fasten
with the screws provided.

You can use the template
supplied to set the thread depths
of the flush rods. Lower flush rod:
–2 mm from the leading edge of
the base plate.
Note:
The Visign for Style 10 actuating plate can be fitted with anti-theft protection
as an optional extra (model 8310.15).
D
Short and long flush volume setting
A
Short flush setting: approx. 3–4 litres
B
Long flush setting approx. 6–9 litres
518913_Visign_f_Style_10.indd 21

Cover

Support
B
Cut in the corners of the in-
spection chamber as far as the
surface of the wall.
E
Then replace the cover.

Screw the flush rods into the
threaded holes on the flush
mechanism. You might first need
to shorten the flush rods by
cutting the threaded section
with the knife.

Fit the support in the
base plate.
21

Set of threaded bolts

Flush mechanism
C
Snap off and dispose of
the ends. The edge of the
inspection chamber must be
flush with the surface of
the wall.
F
Insert the two threaded
bolts into the bore holes inside
the inspection chamber and
lock them in place by turning
through 90°.

You can use the template
supplied to set the thread
depths of the flush rods.
Upper flush rod: –2 mm from
the leading edge of the
base plate.

Connect the actuating
plate to the base plate.
27.10.2009 11:51:17