Publicité
Les langues disponibles
Les langues disponibles
Paring multiple spotlights with separate remotes
If multiple spotlights will be within 200' of one another and you
want to control each spotlight with independent remotes, please
follow the instructions listed.
1. For 1st spotlight, follow the "Pairing of wireless bridge and
hand held wireless remote to spotlight" instructions.
2. For 2nd spotlight, follow instructions above except press and
hold the power button AND the UP button while inserting
the battery in an SPLR-1 remote or connecting power to an
SPLR-2 remote.
3. For 3rd spotlight, follow instructions above except press and
hold the power button AND the RIGHT button while inserting
the battery in an SPLR-1 remote or connecting power to an
SPLR-2 remote.
4. For 4th spotlight, follow instructions above except press and
hold the power button AND the DOWN button while inserting
the battery in an SPLR-1 remote or connecting power to an
SPLR-2 remote.
5. For 5th spotlight, follow instructions above except press and
hold the power button AND the LEFT button while inserting
the battery in an SPLR-1 remote or connecting power to an
SPLR-2 remote.
2
Programming the remote when mounting the spotlight
up side down
NOTE: This procedure reverses the directional buttons on the
remote.
1. Pairing of the remote described above must be completed first.
2. Disconnect all power to the spotlight.
3. Hold down the tilt UP and DOWN buttons on the remote.
4. While pressing the 2 buttons apply power to the spotlight and
continue to hold down the buttons for a few seconds until the
spotlight tilts up or down.
5. The spotlight is now configured for inverted mode.
Release buttons.
6. To return the spotlight to the standard configuration repeat
steps above.
For multiple spotlight applications, please visit the FAQs in the
support center of our website: marinco.com
BEFORE OPERATION REMOVE BLUE FILM
!
WARNING
FROM LENS
Publicité
