Sony Bravia XBR-48A9S Manuel De Référence page 8

Preparing for Wall-Mount Installation
You can use the Wall-Mount Bracket
SU-WL855 (not supplied) to install the TV to
the wall. Make sure to attach the Table-Top
Stand before installing the TV to the wall by
referring to the Setup Guide.
• Prepare the TV for the Wall-Mount Bracket
before making cable connections.
• Follow the instruction guide provided
with the Wall-Mount Bracket for your
model. Sufficient expertise is required in
installing this TV, especially to determine
the strength of the wall for withstanding
the TV's weight.
• Be sure to entrust the attachment of this
product to the wall to Sony dealers or
licensed contractors and pay adequate
attention to safety during the installation.
Sony is not liable for any damage or injury
caused by mishandling or improper
installation.
• The length of the screw for Wall-Mount
Bracket differs depending on the
Wall-Mount Bracket thickness. Please
refer to below illustration.
9 mm – 13 mm
• Be sure to store the unused screws and
Table-Top Stand in a safe place until you
are ready to attach the Table-Top Stand.
Keep the screws away from small
children.
Note
• Read the supplied Safety Booklet for additional
safety information.
* Only on limited region/country/TV model.
8
US
Screw (M6)
Wall-Mount Bracket
TV's rear cover
1
Remove the stand cover and
terminal covers.
2
Remove the screws from the rear of
the TV.
Note
• Be sure to store the removed screws and reuse
when attaching the Wall-Mount Bracket to the
TV set. Keep the screws away from small
children.
Using the optional Wall-Mount Bracket
(Except SU-WL855) (not supplied)
This TV's instruction manual only provides
the steps to prepare the TV for Wall-Mount
installation before it is installed on the wall.
Your TV can be mounted to a wall using a
suitable Wall-Mount Bracket (not supplied).
If the Table-Top Stand is attached to the TV,
the TV may require detaching the Table-Top
Stand; see "Detaching the Table-Top Stand
from the TV".
Prepare the TV for the Wall-Mount Bracket
before making cable connections.