EisSound 42691/A1 Manuel D'utilisation Et D'installation page 25

6.11 Alarms
The control unit is equipped with two alarms that can be individually programmed and can operate in two different modes:
Beep Mode Alarm
Operates whether the control unit is off or on.
\
At the time and days programmed, the control unit powers on and a specific beep signal is sounded. The alarm 1 and alarm 2
\
are different and have programmable volumes.
Is equipped with a "snooze" function: a short key press of any key returns the control unit to its previous state (stand-by or music)and
\
after 4' the beep signal sounds again.
To definitely cancel the alarm, press any key until a continuous beep sounds: it will return to its previous state (stand-by or music) and
\
the alarm function ends.
If the control unit is powered off or on during the "snooze" period, the alarm function ends.
\
Also, if 4' elapse without any key press, the control unit returns to its previous state (stand-by or music) and the alarm function ends.
\
Music Mode Alarm:
Operates only when the control unit is off.
\
At the time and days programmed, the control unit powers on with the last music channel selected.
\
The volume is programmable and different for each of the two alarms.
\
How Is It Programmed?
Access the program menu. Select the on/off status, time and days of the week the
function should operate, as well as the function mode and volume. See 5.1.
Programming Alarm 1 and 2
How Are They Activated/Cleared?
By using the quick functions...
The icons indicate the state of the alarms (activated/cleared).
1 2
Key Sequence Display Visual
alarm 1
1 1 PRG
alarm 2
1 2 PRG
abc
alrm1
1 PRG
alrm2
2 PRG
abc
1 2
23
ENG
beeps