Stroller Assembly; Unfolding The Stroller - Joovy Qool Manuel D'instructions

Stroller Assembly

I WARNING:
tools required.

Unfolding the Stroller

NOTE: Remove packing foam from rear frame assembly to ensure stroller locks in the open position.
• Orient the stroller with the handle facing upward and closest to you. Release the safety latch
located on the left side of the stroller. (1)
• Pull upwards on the handle while putting one foot on top of the basket's rear bar. Keep pulling until
the stroller is fully erected and the latching mechanism on each side engages. (2)
• Visually check and gently push downward on the handle to ensure that the stroller is completely
opened and locked before ANY use of the product.
I WARNING:
unfolding. ALWAYS ensure the folding mechanism on each side of
handlebar is fully engaged when the stroller is in the unfolded position.
This will prevent collapse of the stroller. Possible pinching hazard – Be
careful when unfolding the stroller.
Installing/Removing the Front Wheels
• Slide one front wheel onto the front wheel post until it clicks in place. (3) Repeat for other wheel.
Pull on the wheels to ensure they are installed properly.
• To remove, press the metal release button on the back of the front wheel post and pull away from
the stroller. (4)
Installing/Removing the Rear Wheels
• Install a rear wheel by sliding the axle into the hole in the wheel hub until it clicks into place. (5)
Repeat for other wheel. Pull on the wheels to ensure they are installed properly.
• To remove, pull down the metal release buttons beneath the rear axle bar and pull the wheels from
the stroller. (6)
8
Adult assembly is required for this product. No
Keep children away from stroller while