Davey EcoSalt 2 DES2-15E Instructions D'installation Et D'utilisation page 8

To turn on COVER MODE:
70% – 09:35 AM
CHLORINE OUTPUT
> From the HOME screen, press menu/setting select.
> The display will show this screen:
MODE
1. COVER
> From this screen, press menu/setting select to enter cover mode menu;
> The display will show the current COVER MODE setting (ie COVER MODE off shown):
1. COVER
OFF
menu up/down buttons to toggle between COVER MODE on and off;
> Press the
menu/setting select once your preferred COVER MODE is displayed;
> Press
> This will then take you back to the first setting menu;
> If the EcoSalt2 is left untouched for ~ 30 seconds, or the
pushed, the display reverts to the HOME screen.
menu/setting cancel (go back) button is
14
ACTIVATING BOOST MODE
Should the pool experience a heavy bather load, debris/contamination, or extreme warm weather, there may
be a need to super-chlorinate the pool. Turning on the BOOST MODE increases the cell duty cycle to 100%
and overrides the cell current (output) to 100% for a period of 24 hours.
To turn on BOOST MODE:
70% – 09:35 AM
CHLORINE OUTPUT
> From the HOME screen, press menu/setting select.
> The display will show this screen:
COVER MODE can also be triggered remotely
by an automated pool cover controller. By
closing the terminal block contacts on the
rear of the power supply, the EcoSalt2 will
remotely switch to COVER MODE. This
can be overridden by user intervention, by
following the steps explained previously.
15