CALOR 6610 Notice D'emploi page 11

1
SINGLE-POWER CONVECTOR MODELS:
Mod. 6616: (1 control knob)
The appliance is ready to operate as soon as you plug it in.
Set the required temperature, by turning the thermostat dial.
To turn off the appliance, turn the thermostat
to the frost-free position
2
OTHER MODELS:
Choose the appropriate power setting
The power needed to heat a room mainly depends on:
- the volume of the room
- the insulation of the floor, the walls, the windows and the ceiling.
In practice, you need 90 W per m
Caution! Every room is different. For example, good insulation can reduce electrical heating consumption by up to 70%. However, with
poor insulation, you may require 160 W per m
Using the control dial, choose the most appropriate power setting for the room you wish to heat.
To reach the required temperature quickly, select the fan (models 6670/6672) or full power position.
DUAL POWER CONVECTOR MODELS
Mod. 6610
(2 control knobs)
To turn it on, turn the control dial to the required setting:
- half power (750 W)
- full power (1500 W)
To turn it off, turn the dial back to its initial position
FAN MODELS
The fan heater position provides faster and more uniform heat distribution.
Mod. 6670 (single-power convector or fan heater)
(2 control knobs)
To turn it on, turn the control dial to the required setting:
- half power (2000 W)
- fan (2000 W)
To turn it off, turn the dial back to its initial position
and unplug the appliance.
2 (with a ceiling height of 2.5 m and standard insulation conditions).
2 .
.
.
Mod. 6618: (2 control knobs)
To turn on the appliance,
turn the control button to position
To turn it off, turn the button back
to the initial position .
Mod. 6620
(2 control knobs)
To turn it on, turn the control dial to the required setting:
- half power (1000 W)
- full power (2000 W)
To turn it off, turn the dial back to its initial position
Mod. 6672 (dual-power convector or fan heater)
(2 control knobs)
To turn it on, turn the control dial to the required setting:
- half power convector (1000 W)
- half power convector (2000 W)
- fan (2000 W)
To turn it off, turn the dial back to its initial position
.
.
.
ENG