Ventura PB80 Guide De L'utilisateur page 7

Warning!
1. When jump starting a vehicle ensure that the jump starter cable is
correctly and tightly connected to the jump start socket on your PB80.
2. Ensure that the jump start cable clamps are correctly connected to
the positive (+) and negative (-) terminals of the vehicle's battery before
attempting to jump start your vehicle. Before connecting the clamps,
ensure that the battery terminals are clean. Do not attempt to jump
start your vehicle more than 3 times in quick succession as you will
damage your PB80.
3. Do not reverse the polarity. Reversing the polarity will damage your
PB80 and invalidate the warranty.
4. Do not disassemble your PB80; there are no user-serviceable parts
inside. Disassembling your PB80 may result in exposure to shock and/or
electrical or mechanical hazards and will invalidate any warranty.
!
Always take care when using the appliance
Your PB80 is not intended for use by young or infirm persons without
supervision
Do not use as a toy
Do not allow your PB80 to become wet
Do not immerse your PB80 in water
Do not operate your PB80 in explosive atmospheres, such as in the presence of
flammable liquids, gases or dust
Do not modify or disassemble your PB80
Do not expose your PB80 to extreme heat.
Do not store in locations where the temperature may exceed 70°C
Charge only at ambient temperatures between -20°C and 60°C
!
Charge only using the chargers provided with your PB80.
Under extreme conditions, battery leakage may occur. Carefully wipe the
!
liquid off using a cloth and avoid skin contact. In case of skin or eye contact,
rinse immediately with clean water and seek medical attention. Service under
Warranty
UK • 7