Closing The Doors And Leveling - LG LTCS20220 Série Manuel D'utilisateur

Tighten the bolts. Force-fit Top Hinge Cover over Top
Hinge.
Replace cover on the top left side of the refrigerator
to the right top to cover the holes. Cover is also
force-fitted.
Cover (on top of
refrigerator)
After changing doors, make sure that the corners
of the Door Gaskets are not folded over. To ensure a
good seal, apply a small amount of silicon grease on
the corners of gaskets.
REFRIGERATOR INSTALLATION REFRIGERATOR INSTALLATION

CLOSING THE DOORS AND LEVELING

To avoid vibration, the unit must be leveled. If necessary,
adjust the leveling legs to compensate for unevenness
of the floor. The front should be slightly higher than the
rear to aid in door closing.
The refrigerator has two front leveling legs, one on
the right and one on the left. If your refrigerator seems
unstable or if you would like the doors to close more
easily, simply adjust the tilt of the refrigerator by
following the instructions below:
1. Plug the refrigerator into a 3 prong grounded outlet.
2.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling legs.
This will make it easier to adjust the level.
3. Open both doors again and check to make sure that
Corners
11
Move the refrigerator into its final position.
Use an 11/16" (18 mm) wrench or an adjustable
wrench to adjust the leveling legs, turn the leveling
legs to the left to raise that side of the refrigerator or
to the right to lower it. It may take several turns of the
leveling leg to adjust the tilt of the refrigerator.
they close easily. If they don't, tilt the refrigerator slightly
more to the rear by turning both leveling legs
to the left. It may take several more turns, and you
should extend both legs theamount.
Door Alignment
If the space between your doors is uneven, follow the
instructions below to align the doors:
1. Gently pry off the Top Hinge Cover with a flat head
screwdriver and remove.
2. Loosen the Top Hinge Bolts using a 10 mm or 13/32
inch socket wrench or open-end wrench.
3. Have someone hold the freezer door so the space
between the two doors is even, and retighten the top
hinge bolts.
4. Replace the Top Hinge Cover.