Adding Channels To The Tv's Memory; Programming Channels Automatically; Adding And Erasing Channels Manually; Changing Channels - Toshiba 27AF53 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Adding channels to the TV's memory

Your TV will stop on specific channels that are stored in the TV's
channel memory when you press Channel L or M. Use the steps
below to set all active channels in your area automatically.

Programming channels automatically

Your TV can automatically detect all active channels and store them in
its memory. After the TV has stored the channels in its memory auto-
matically, you can add or erase channels manually.
To add channels automatically:
1. Press MENU, then press
2. Press L or M until the TV/CABLE
selection is highlighted.
3. Press
or
to highlight either
TV or CABLE, depending on
which you use.
If you use an antenna, choose TV.
If you use cable, choose CABLE.
4. Press M to select CH PROGRAM.
5. Press
or
to start channel programming. The TV will automati-
cally cycle through all the TV or Cable channels (depending on
which you selected), and store all active channels in the channel
memory.
While the TV is cycling through the channels, the message
"PROGRAMMING NOW-PLEASE WAIT" appears.
6. When channel programming is complete, the message "COMPLETED"
appears.
7. Press CH L or M to view the programmed channels.

Adding and erasing channels manually

After you have programmed the channels automatically, you can add or
erase specific channels manually.
To add or erase channels manually:
1. Select the channel you want to add or erase.
If adding channels, you must select the channel to add using the
Channel Number buttons.
2. Press MENU, then press
to display the SETUP menu.
3. Press L or M to highlight ADD/
ERASE.
4. Press
or
to select ADD or
ERASE, whichever function you
want to perform.
5. Repeat steps 1-4 for other
channels you want to add or erase.

Changing channels

To change to the next programmed channel:
Press Channel M or L on the TV or CH L or M on the remote
control.
To change to a specific channel (programmed or unprogrammed):
Press the Channel Number buttons (0-9 and 100) on the remote
control.
For example, to select channel 125, press 100, 2, 5.
or
to display the SETUP menu.
CH
PICTURE AUDIO
SETUP
MODE
CLOSED CAPTION OFF
TV / CABLE
TV CABLE
CH PROGRAM
START
ADD / ERASE
ADD
SELECT
ADJUST
or
CH
PICTURE AUDIO
SETUP
MODE
CLOSED CAPTION OFF
TV / CABLE
CABLE
CH PROGRAM
START
ADD / ERASE
ADD ERASE
SELECT
ADJUST
17
OPTION
OPTION
Channel
Numbers
Menu
Exit
Channel LM

Publicité

Chapitres

Table des Matières

Dépannage

loading

Table des Matières