Setting up your TV
After you have installed the batteries and programmed the remote
control, you need to set some preferences on the TV using the menu
system. You can access the menu system with the buttons on the
remote control.
• When you make a menu selection, your changes occur immedi-
ately. You do not have to press MENU or EXIT to see your
changes.
• After five seconds, the menu screen will automatically close if you
do not make a selection. Your changes will still be saved.
• When you are finished programming the menus, press EXIT.
Changing the on-screen display language
You can choose from three different languages (English, French and
Spanish) for the on-screen displays. Adjustment menus and messages
will appear in the language of your choice.
To select a language:
1. Press MENU, then press
CH
PICTURE AUDIO
SETUP
MODE
OPTION
LANGUAGE
ENGLISH
CH LABEL
START
FAVORITE CH
START
V-CHIP
START
LOCK
START
ON/OFF TIMER
OFF
COLORSTREAM
DVD
IMAGE TILT
SELECT
ADJUST
2. Press L or M to highlight LANGUAGE.
CH
PICTURE AUDIO
SETUP
MODE
OPTION
LANGUAGE
ENGLISH
CH LABEL
START
FAVORITE CH
START
V-CHIP
START
LOCK
START
ON/OFF TIMER
OFF
COLORSTREAM
DVD
IMAGE TILT
SELECT
ADJUST
3. Press
or
to highlight your desired language.
Image tilt correction
When you install or change the direction of the TV, the picture may
become tilted (caused by the Earth's magnetism). If this happens, use
the image tilt correction feature to obtain the best possible picture.
To adjust the image tilt:
1. Press MENU, then press
2. Press L or M to highlight IMAGE TILT.
3. Press
or
to adjust the picture tilt (from –10 to +10).
IMAGE TILT
0
ADJUST
or
until the OPTION menu appears.
0
0
or
until the OPTION menu appears.
16
Menu
Exit