Installation; Clearance To Combustibles - HAMPTON BAY LI-24 Guide D'utilisation Et D'entretien

Installation

Your new electric log set with heater can be installed
in several ways:
□
Into an existing fireplace
□
On a solid floor up against a solid wall
□
Into any opening or enclosure that meets the clearances to
combustibles listed
Simply place your electric log set in the desired location, observing
the clearances and notes in this manual, and plug the cord into a
minimum 15 amp, 120 Volt electrical outlet. Use an extension cord
rated for a minimum of 1,875 watts if necessary.
WARNING
Do not install the unit on shelves, raised platforms, beds, blankets, pillows etc. Keep combustible materials such as furniture, bedding,
papers, clothes and curtains at least 3 ft. (914 mm) from the log insert.
MINIMUM ENCLOSURE SIzE
UNPACKING
Remove the unit from the carton and make sure that all parts are present and carefully check for damage. If any part is missing or
damaged, do not attempt to assemble or use the product. Contact Customer Service for help at 855-HD-HAMPTON.
DO NOT dispose of packaging until you are satisfied with your log set.
DO NOT return the product to the store before calling 855-HD-HAMPTON for assistance.

Clearance to Combustibles

Sides
Floor
Top
Front
Rear
Model #LI-24
9
PLEASE CONTACT 855-HD-HAMPTON FOR FURTHER ASSISTANCE.
4-1/8 in. (105 mm)
0 in. (0 mm)
3/8 in. (10 mm)
36 in. (915 mm)
3/4 in. (19 mm)
HAMPTONBAY.COM