Cleaning & Care; Battery Removal - Remington Pivot & Flex R4150 Guide D'utilisation Et D'entretien

Cleaning & Care
The shaver is a washable appliance. The head
assembly part may be cleaned under warm water.
NOTE: **When cleaning your shaver, make sure the shaver is turned off
and disconnected from the power cord.**
CAUTION!
■ To clean the external surfaces of the shaver, use a damp cloth. Do not use strong
detergents or other chemicals.
■ To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer
or heater to dry the shaver.
■ The shaver should not be used until it has dried.
I J
N
M
Q
R
Daily:
1. Press the release button on front of shaver and open
head assembly. (Diagram I)
2. Tap out excess hair shavings. (Diagram J)
3. Rinse the head of the shaver in running water.
NEVER submerge the shaver in water!
4. Close head assembly. (Diagram K)
8
K
L
O
P
S T
U
Monthly:
1. Perform the daily cleaning steps 1 and 2.
2. Remove the cover from the hair pocket assembly. (Diagram L) Place the body of
the shaver aside to ensure that it will not get wet.
3. Place a drop of liquid soap on each cutter. (Diagram M)
4. Brush the soap around vigorously using the supplied cleaning brush. (Diagram N)
5. Release the inner cutter carrier by rotating the locking arms counter-clockwise.
(Diagram O)
6. Remove the inner cutter carrier away from the cutters. (Diagram P)
7. Remove the cutters. (Diagram Q)
8. Thoroughly brush any hair off of the inner and outer cutters (Diagram R) and
rinse away any soap and debris from inner and outer cutters. (Diagram S)
9. Replace the inner cutters. (Diagram T)
10. Place the inner cutter carrier back into position and lock into place by rotating
the locking arms clockwise until they snap into place. (Diagram U)
11. Lubricate each cutter with household oil.
12. Close the head assembly. (Diagram K)
** Trimmer: Lubricate teeth with oil every six months

Battery Removal

When your rechargeable shaver reaches the end of its useful life, the Ni-MH bat-
teries must be removed from the shaver and be recycled or disposed of properly
in accordance with your state and local requirements. If this is not required by
law, you may elect to dispose of the shaver with the batteries.
CAUTION! Do not put in fire or mutilate your batteries when disposing as they
may burst and release toxic materials. Do not short circuit as it may cause burns.
Dispose of properly in accordance with your local and state requirements.
To Remove the Rechargeable Battery:
1. Unplug the shaver.
2. Run shaver until motor stops.
3. Remove head from shaver (Press release button and pull head straight away
from shaver body)
4. Using a small screwdriver pry front cover from shaver body.
5. Remove four screws located on front of shaver.
6. Remove rear cover from inner housing to expose batteries.
7. Pry batteries free from circuit board and cut wires.
8. Dispose of batteries.
9