LABBOX EASY 20K Mode D'emploi page 6

5.3 Connecting the filling tube
Cut off the bottom of the filling tube diagonally.
-
Push the filling tube into the valve block as far as possible – with the diagonal end down.
-
5.4 Mounting the instrument on the bottle
- Can be done by screwing directly onto a GL 45 screw thread. For other bottles use the
included adapters.
- Hold the discharge tube and carefully remove the cap
-Slide the cap lock backwards on the tube support, away from the discharge tube.
Attention:
The adapters supplied with the instrument are made of
-
polypropylene (PP), and can only be applied for media
which does not attack PP
For small bottles use a bottle stand to prevent tipping
-
over
-Reagent may drop off the discharge tube end and cap,
be careful.
6
.