Basic Operation - Philips HD 1500 Mode D'emploi

XP SBC HD 1500/17 for USA 14-01-2004 13:34 Pagina 35
3 Upsampling:
– Some SACD players allow for audio CDs to be upsampled from
– When connecting your SACD player to the HD1500 base station
– The HD1500 base station will recognize the following digital input
IMPORTANT!
• In case of connecting a Super Audio CD player to the HD1500
• When connecting a DVD player to the HD1500 base station: do
In case an invalid digital signal is detected - for example a digital MP3 data
stream - the 'DIGITAL' indication LED in the HD1500 display window will
be illuminated in red. In case a valid digital signal is detected - for example a
digital DTS data stream - the 'DIGITAL' indication LED will be illuminated in
green.

Basic operation

When the base station is connected to a:
- analogue line output of an analogue stereo source
(stereo TV, stereo VCR, (S)VCD player, tape
recorder, etc.)
- digital electrical coaxial S/PDIF output of a stereo
source (CD player with S/PDIF output, etc.) or a
multichannel source (DVD player with S/PDIF
output, etc.)
1 Switch on your audio source.
2 Switch on the HD1500 base station: the power indicator will change from
red to green.
44.1 kHz/16 bit to various higher sampling rates.
through the digital coaxial S/PDIF connector, you should not upsample
the audio signal.
signals:
– Stereo LPCM with sample frequencies 44.1 kHz and 48kHz
– Dolby® Digital (AC-3), up to 5.1 channels
– DTS®, up to 5.1 channels
base station making use of the SACD player's digital outputs: do
not upsample the Super Audio CD digital output signal higher than
44.1 kHz.
not upsample the DVD digital output signal higher than 48 kHz.
ENGLISH 35