Adjusting Air Flow Direction - Dyna-Glo EG7500DH Guide D'instructions

ADJUSTING AIR FLOW DIRECTION

1. To turn the unit when it has been
installed with a single lag bolt (as
shown in figure 4a), simply turn the
entire heater as needed. The unit
cannot be turned horizontally if it has
been installed with 2 lag bolts.
2. To tilt the unit vertically, loosen the
bracket screws (see figure 5).
NOTE: For the heater to be tilted vertically,
it must be mounted in bottom keyhole
slots of mounting brackets to maintain
adequate clearance and prevent possible
overheating.
3. Adjust louvers to the desired position (see Figure 6).
NOTE: The louvers are designed so they cannot be completely closed. Do not
attempt to defeat this feature; damage to the unit can result.
To prevent possible electric shock, disconnect power to the heater at the
main service box before attempting to adjust the heat output of this unit.
45 degrees
90 degrees
Figure 6
WARNING
MULTIPLE VERTICAL ANGLES
CEILING
90 degrees 6 7 5 . d e g e r s e
7
Figure 5
4 5 d e g e r s e