Putting Into Service - Star Lab GuardOne Manuel

5

Putting into service

Preconditions:
› The GuardOne ® Workstation is fully assembled.
› The main power switch is turned to ON.
› The serial numbers of Hepa filter and UV Lamp have been entered into the graphical user interface
(Chapter 4.6 "Complete Installation" on page 22).
› The function test was successful.
Adjusting date and time
1. Press the date and time symbol (1) in the upper left corner of the infor-
mation bar of any page to open the Date/Time page.
2. Change any value by pressing the value (2) and adjust it with the + and
- button (3).
3. To save your changes, use Save Settings (4).
4. To exit the page, use Back or Home.
Exiting the page without using Save Settings will discard all changes
you have made!
Adjusting the default operation parameters
1. Press Settings on the Home menu.
The Quick Start button on the Home menu will start the GuardOne
Workstation with default values for blower speed and LED light. The
factory settings for the Quick Start are 50 % blower speed and LED
lights off.
2. Press Quick Start Settings to open the setup page for changing the
factory settings.
3. Change any value by pressing onto the corresponding buttons (1) and
adjust the settings using the + and - button
4. To save your changes, press Save (3).
5. To exit the page, use Back or Home.
Exiting the page without using Save will discard all changes you have
made!
®
(2).
Putting into service
Fig. 25: Adjusting date and time
Fig. 26: Quick Start
GuardOne
25
® · Manual ·