GE JGP628 Instructions D'installation page 13

MAKInG THe LP ConverSIon
If sold outside the u.S. and Canada:
WArnInG:
If you wish to use this product
with Liquefied Petroleum (LP) gas containing greater
than 10% butane, you must purchase a butane
conversion kit. To order,
please call 1.888.664.8403 or 1.787.276.4051.
Model
JGP970
ZGU36
JGP975
JGP963
JGP630
JGP628
SAfeTY InforMATIon You
1
SHouLD KnoW
The pressure regulator and burner orifices are set
for natural gas. To use LP gas, the regulator and
burner orifices must be converted. The LP orifice
spuds for the cooktop burners can be located in the
literature package attached to the regulator.
CAuTIon:
The cooktop, as shipped from
the factory, is set for use with natural gas. If you
wish to use your cooktop with LP gas, you must
first replace the orifices and convert the pressure
regulator.
WArnInG:
This conversion must
be performed by a qualified installer or gas supplier
in accordance with the manufacturer's instructions
and all codes and requirements of the authority
having jurisdiction. Failure to follow instructions could
result in serious injury or property damage. The
qualified agency performing this work assumes
responsibility for the conversion.
CAuTIon:
The following adjustments
must be made before turning on the burner.
Failure to do so could result in serious injury. Be
sure pressure regulator has been converted as
described in Step 2.
Installation Instructions
Butane Kit #
WB28T10229
WB28T10229
WB28T10231
WB28T10233
WB28T10235
WB28T10236
TooLS You WILL neeD
for LP ConverSIon
Phillips- Head
Screwdriver
Pliers
Safety Glasses
ADjuST Your CooKToP for uSe
2
WITH LP GAS
Disconnect all electrical power, at the main
A
circuit breaker or fuse box.
Shut off the gas supply to the cooktop
B
by closing the manual shut-off valve.
Adjust the pressure regulator, by the following
C
instructions:
• Unscrew the cap.
• Place your thumb against the flat side of the
spring retainer and press down to remove
the retainer.
• Carefully look at the spring retainer to locate
the NAT or LP position.
NAT
NAT
NAT.
Position
• Turn the spring retainer over so that
LP is showing on the bottom.
• Snap the retainer back into position.
• Screw the cap back onto the regulator.
13
7mm Nutdriver
No. 15 Torx-Head
Driver
Small Flat-Head
Screwdriver (4mm or
5/32" tip size, 60mm
long)
Gasket
Cap
LP
Spring
Retainer
LP
L.P./Propane
Position
Pressure Regulator