Control Panel Operation - H.Koenig MG15 Manuel D'utilisation

19. Always attach plug to appliance first, then plug cord into the wall outlet. To
disconnect turn any control to "off", then remove plug from wall outlet.
20. Do not use coffee machine with a damaged outlet.
21. Do not forget that the temperature of the coffee prepared is high. Handle with care
your coffeepot to avoid any risk of splashes.
22. Any examination, repair, or adjustment for the appliance should be made by the
authorized service agent.
23. Save this instruction for future use.
24. Never immerse the appliance in water or any other liquid.
1. Uncover the top cover and fill clean water to required level.
2. Put adequate quantity of coffee powder or tealeaves in the filter cone.
3. Place the carafe on the hot plate.
4. Place the tundish with the filter cone in the tundish support.
5. Close the top cover.
6. Switch on, the indicator lamp will light up and the machine begin working.
7. After boiling, when no water in tank if you keep switch on and the carafe on
heating plate, this will remain the coffee or tea warm. The water in carafe can be
warm at: a.above 75℃ in half an hour. b.above 70℃ in an hour.
1. When connect to power, LCD display "12.00", "RUN" and "AUTO" lamp not
indicate.
2. Press "ON/OFF" button one time, "RUN" lamp light and start brewing LCD display
clock.
3. AUTO operate procedure :
(1) After press "ON/OFF" button two times. "RUN" lamp indicator off. "AUTO" lamp
on.
(2) Clock setup :
A) After press "PROG "button one time, LCD display "CLOCK", it means that clock is
in setup state. Press "HOUR" button first time, LCD display "13:00". LCD will display
increase 1 hour after press every time. If you remain press "HOUR" button above 1
second, then the time will increase about 4-5 hours quickly per second.
B) Minute setup : at this, press "MIN" button above 2 seconds, then the time will
increase quickly about 4-5 minutes per seconds.
C) A fire setting time, press "PROM" button until the hour and minute on LCD all
Disappear. Then LCD counter normally if you want to rest the time, repeat A-C.
OPERATION

CONTROL PANEL OPERATION