Control Panel Operation - H.Koenig MG15 Manuel D'utilisation

19. Always attach plug to appliance first, then plug cord into the wall outlet. To
disconnect turn any control to "off", then remove plug from wall outlet.
20. Do not use coffee machine with a damaged outlet.
21. Do not forget that the temperature of the coffee prepared is high. Handle with care
your coffeepot to avoid any risk of splashes.
22. Any examination, repair, or adjustment for the appliance should be made by the
authorized service agent.
23. Save this instruction for future use.
24. Never immerse the appliance in water or any other liquid.
1. Uncover the top cover and fill clean water to required level.
2. Put adequate quantity of coffee powder or tealeaves in the filter cone.
3. Place the carafe on the hot plate.
4. Place the tundish with the filter cone in the tundish support.
5. Close the top cover.
6. Switch on, the indicator lamp will light up and the machine begin working.
7. After boiling, when no water in tank if you keep switch on and the carafe on
heating plate, this will remain the coffee or tea warm. The water in carafe can be
warm at: a.above 75℃ in half an hour. b.above 70℃ in an hour.
1. The LCD displays time, 12.00 by default on the first connection.
Press once the "ON / OFF" button "RUN" will light up and you can set the clock.
Set the clock:
A) Press once the "PROG" button, the screen will display "CLOCK", then you can set
the clock. Press "HOUR" This will change the hour. To speed up, you can hold the
"HOUR" button pressed, otherwise the time forward one hour each time you press the
button.
B) For minutes, just press the button "MIN". The operation is identical to that for hours.
2. C) After setting the time, press "PROG" until "CLOCK" disappears from the screen.
3. AUTO Programming:
If you press twice on the "ON / OFF" button instead of "RUN", the LED "AUTO" will
light.
Automatic programming:
(A) Press twice the "PROG" button, the display shows "TIMER". Sever then the time
("HOUR") and minutes ("MIN"). After the selected time, press "PROG" and the word
"TIMER" disappear.
(B) The unit will automatically start at the scheduled time.
OPERATION

CONTROL PANEL OPERATION