Installation & Operation - Samlexpower SCC-1208L Manuel Du Propriétaire

SECTION 4 |
!
CAUTION!
1. The unit has internal protection circuits that are activated only when a
battery is connected to the unit. Hence, please ensure the following to
protect the unit against damage:
• Always connect the battery first and then the solar panel / array.
• Do not disconnect the battery when the solar panel / array is con-
nected. If the battery is required to be removed for servicing / re-
placement, remove the solar panel / array first and then the battery.
2. A battery is an unlimited source of current and can drive thousands
of Amperes of current into a short circuit across its terminals. If there
is a short circuit along the path of the battery connecting wires from
the battery to the controller, the section of wires from the battery to
the point of short circuit will melt and burn and may cause injury/ fire.
Hence, always install a current limiting type of fuse e.g. Class T fuse or
equivalent as close to the battery Positive terminal as possible (prefer-
ably within 7" from the battery Positive terminal).
3. Doubly check the polarity of the connections with the help of a multi-
meter. Ensure that Positive is connected to Positive and Negative to
Negative. Avoid connecting in reverse polarity. The unit has internal,
self resetting protection against reverse polarity on the battery side.
4.1 ACCESSORIES PROVIDED FOR INSTALLATION
(a) Mounting Screws: Flat head, self-tapping ; 2.9 mm dia. ; 1.1 mm pitch ; 9.5 mm long ;
Phillip drive.
(b) Mounting Adhesive Strip: 60 mm x 10 mm x 1.5 mm
(c) 6 pieces of Twist-on Wire Nut Connectors for connection of input and output wiring.
Connection procedure is given below:
First, insert two wires together into connector cap, and then turn the cap until the
two wires twisted tightly. Follow sequence 1 to 4 shown in the pictures given below.
1
10 | SAMLEX AMERICA INC.
Installation & Operation
2 3 4