Kingfisher GoodHome Florya Mode D'emploi page 43

Installation
Horizontal model
Fixation
holes
Appliance
Bottom
Power
L1 (mm)
1. Disassemble the wall bracket by loosening the screw (do
not remove, only loosen) and slide the metal plate out of
the hole. Take out the bracket by pulling down.
2. To faciliate obtaining the minimum dimension of 250 mm
(from the bottom of the appliance to the floor), simply
place the wall bracket against the wall with the bottom lugs
on the floor and make marks for Item A (step 1 Fig. C).
Move the bracket up until Item B (step 2 Fig. C) reaches
the marks of Item A and make marks at Item C (step 2 Fig.
C). Move up the bracket again until Item D (step 3 Fig. C)
reaches the marks of Item C.
Make sure the bracket is even by using a spirit level. Mark
the 4 mouting holes and start drilling. Fix the H support on
the wall by using adapted screws and plugs (not provided).
Do not use any adhesive as fixing means.
195279_s1_s1_3663602437277_GOODHOME_A5_IM_Multi_V09.indb 43 195279_s1_s1_3663602437277_GOODHOME_A5_IM_Multi_V09.indb 43
Wall
bracket
lock
Footprint
of the
appliance
Item D
Fig. C
1000 W 1500 W 2000 W
185 355
Step. 3
Mounting
holes
Step. 2
Appliance
height
Item B
Floor
355
43
Item C
Step. 1
Item A
13-05-2020 12:55:36 13-05-2020 12:55:36