Overview; Putting Into Operation - Venta Luftwäscher LP6O Mode D'emploi

OVERVIEW

1 Display
On/off switch
2
3 Fragrance/filter compartment
Fragrance holder
4
5 Pre-filter
VENTAcel filter
6

PUTTING INTO OPERATION

01 06
Attention! Make sure that the appliance is switched off and the
power plug is disconnected.
01 Unpack the appliance and set it up. Open the fragrance/filter compartment
3+7, remove the pre-filter 5+9, the VENTAcel filter 6+10 and unpack them.
Re-insert the VENTAcel filter 6+10 and pre-filter 5+9.
02
Inserting the fragrance: Twist open the fragrance cap and insert it into
03
the fragrance holder 4/8. Insert up to three fragrances into the fragrance
holder 4+8.
Close the fragrance/filter compartment 3+7.
04
The display 1 can be adjusted to three positions.
05
The power cable can be adjusted to the desired length by winding it up in
06
the cable compartment 11
Attention! The coupling of the mains cable must be plugged firmly into the
device!
Please remove the protective foil for
battery and remote control.
Connect the power plug and
switch on the appliance at the on/
off switch 2 or with the remote
control 12.
7 Fragrance/filter compartment
Fragrance holder
8
9 Pre-filter
10 VENTAcel filter
11 Cable compartment
12 Remote control
ON/OFF
Set fan stage
Venta LP60 GB 12