LP WGC Série Mode D'emploi page 7

Natural Gas Orifice Spud Chart for Kit W10676662
Burner Color Stamp
Rating (A)
6,000 BTU White 110
7,000 BTU Green 118
10,000 BTU Black 142
12,00 BTU Orange 155
17,000 BTU
Inner Blue 91
Other Brown 167
18,000
Inner Blue 91
Outer Yellow 172
20,000 BTU
Inner Blue 91
Outer Red 185
10,000 BTU N/A
Inner Pink
Outer Pink
Burner Models for Kit W10676662
Model No. Left Left
Front Rear
KCGS550E 110 142
White Black
KCGS556E 110 142
White Black
KCGS950ES 110 142
White Black
KCGS956ES 110 155
White Orange
Burner locations
B
A
A. Left front
B. Left rear
C. Center
5. Remove all burner caps and burner bases (see the User
Guide for burner reference).
Size
1.10 mm
1.18 mm
1.42 mm
1.55 mm
0.91 mm
1.67 mm
0.91 mm
1.72 mm
0.91 mm
1.85 mm
N/A
A. Size stamp
Center Center Right Right
Inner Outer Rear Front
Inner
167 91 118 142
Brown Blue Green Black
172 91 118 142
Yellow Blue Green Black
167 91 118 N/A
Brown Blue Green
185 91 118 N/A
Red Blue Green
C D
D. Right rear
E. Right front
To remove the burner base for the Dual Flame and Dual Tier
Ultra Torch burners use a Torx
screw.
A
B
A
C
D
Dual Tier Ultra Burner
A. Inner burner cap
B. Outer burner cap
C. Gas tube opening
Right
Front D. Burner base
Outer
142
Black
142
Black
N/A
N/A
6. To Convert Standard Burner:
E
Use 7.0 mm wrench to loosen and remove the orifice
spud (A).
Set gas orifice spud aside.
Replace with correct Natural gas orifice spud. See Natural
gas orifice spud charts.
7. To Convert Dual Tier Ultra and Dual Flame Burners:
Use 7.0 mm wrench to loosen and remove the inner
orifice spud (A) and the outer orifice spud (B).
Set gas orifice spuds aside.
®
T10 driver to remove the
B
Standard and Dual
A. Burner cap
B. Igniter electrode
C. Burner base
D. Gas tube opening
A
B
C
D
E
Even-Heat™ Torch Burner
A. Inner burner cap
B. Inner burner base
C. Outer burner base
D. Burner support
E. Gas tube opening
A
A. Orifice spud
A
D
C
Flame
7