Checking For Leaks - Glacier bay 874W-1004 Guide D'utilisation Et D'entretien

Installation (continued)
9

Checking for leaks

□
Place the handle (F) on the valve body (D)
inverter and turn the handle to the full on mixed
position.
□
When the valve is turned on, water normally
ows through the tub spout (J). To activate the
shower, turn the valve on and pull the knob (1)
up. Hold the knob (1) until the water ows
continiously from the shower arm (B). Check for
leaks.
□
Shut off the water at the faucet and supply lines.
Remove the handle (F).
B
F
J
UP
FOR
SHOWER
1
J
10
Installing the escutcheon
and handle
□
Install the escutcheon (E) onto the valve body
(D) using the escutcheon screws (AA). Place
the handle assembly (F) onto the valve body (D),
and secure it with the screw (G).
□
Use a Phillips screwdriver to tighten the screws
(AA and G).
□
Insert the index (H) into the handle (F).
F
G
H
D
9
Please contact 1-855-HD-GLACIER for further assistance.
E
AA
D
HOMEDEPOT.COM