Mounting The Ice Maker - Whirlpool EZ CONNECT Guide D'installation

Mounting the Ice Maker

Refer to the side diagrams for the following
steps.
7. Position the ice maker inside the freezer
compartment and connect its wiring
connector to the wiring harness connector
so they lock together (the locking arm will
snap over the raised tab). The connectors
will fit together only one way.
8. Hang the ice maker from the tabs on the
shoulder screws shown earlier. Make
sure that the bracket mounting hole
is aligned with the mounting hole in
the freezer liner.
NOTE: Guide fill tube into water cup hole.
9. Mount the ice maker to the freezer liner
mounting hole with the
sheet-metal screw provided.
6
"
⁄ hex-head
1
2
Connectors
Bracket
Mounting Hole
Mounting the ice maker
Water cup