Télécharger Imprimer la page

Eurotops S 1030 Manuel D'utilisation page 11

Publicité

Les langues disponibles

Les langues disponibles

S 1030 / OT1003FC
 Press "Set" to confirm the setting and move on.
 Press "UP" / "DOWN" once to advance or reverse the setting.
 Hold these buttons down to scroll faster the setting change
 The unit will exit the setting mode if no key is pressed for 8 seconds.
2. Navigation between settings
 Hold 2 seconds the button "set" to enter the mode "setting the time."
 Press "Alarm" to activate / deactivate the alarm.
 Hold two seconds "Alarm" to enter the mode "alarm setting."
 Press "up" to switch from 12h to 24h.
 Hold the "Down" button for 2 seconds to search for the DCF signal.
 When you are under DCF reception, press "Down" to exit the DCF reception
 Press "Down" to switch between ° C and ° F
 Press "Snooze / Light" to illuminate the screen for 5 seconds.
 Be sure by pressing the button "CH" that the device is set to "CH1" which indicating the data
of the external sensor. "CH2" and "CH3" are not available on this camera
 Press "Max / Min" to check the maximum and minimum temperatures and humidity
recorded.
 Hold "Max / Min" to delete the recorded data.
The European directive 2012/19/EC about electronic and electric waste, requires that you can't throw away defective domestic
appliance with common waste. Used device has to be collect separately to optimize the recuperation rate and the recycling of the materials
to reduce the impact on the health and the environment.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capacities, or by persons
lacking in experience or knowledge, unless they are supervised or instructed on the use of this apparatus by a person responsible for their
safety.Children should be supervised to ensure they do not play with this appliance.
Precision and precautions about the battery use
o
Throwing away a used battery in the environment or with household waste pollutes and avoids the recuperation of reusable materials.
o
It is important to limit the battery consumption and to respect the following rules:
Favor alkaline battery (last longer than saline battery) and when it's possible use rechargeable battery.
Leave used batteries and accumulators in adapted containers that you can find in some retailers. In that way, metals don't pollute the
environment and the health.
o
Battery has to be inserted by respecting the polarity show on the apparel and the battery. An incorrect positioning can damage the
apparel, cause leaking and even provoke fire and the explosion of the battery.
o
To assure a good functioning, battery has to be in a good condition. If there is a problem, put new battery.
o
Never try to recharge battery not made for this. It could leak, warm up, cause fire or explode.
o
Replace all the battery at the same time. Never mix up alkaline battery with saline battery.
o
Used battery has to be removed.
o
Also, remove the battery if you're not using the apparel for a long time.
o
Never try to short-circuit the terminal of a battery.
o
Never throw away the battery in fire because they can explode.
o
Take out the accumulator from the apparel before reload it.
o
We recommend that an adult watch if a child change the battery to respect those rules.
o
If you swallow a battery, go immediately to your doctor or the hospital.
Imported by
CAPTELEC, 24 RUE DE MARCQ, 59290 WASQUEHAL, France
CAPTELEC - FRANCE
59 290 – Wasquehal

Publicité

loading

Ce manuel est également adapté pour:

Ot1003fc